Bearing heaters for hire
Fitting bearings safely without the expense of buying a heater
Increase machine uptime
Increase uptime by reducing bearing failure
16% of premature bearing failures can be attributed to poor fitting. Bearing heaters are an effective method of mounting bearings correctly.
Flexible & economical heater hire
Hiring a bearing heater for a few days will cost less than purchasing. Hire for just a day, a week or even a month, or simply try before you buy! - We're very flexible, the choice is yours.
Hire the mobile bearing heater TWIM 15
Hire rate for 1st day: £200
Each consecutive day thereafter: £95 per day
Use the TWIM15 230v induction bearing heater to fit bearings with a bore diameter from 20mm and a maximum outer diameter of 320mm. The TWIM 15 can be used to heat bearings and other ring-shaped, metalic components up to a maximum component weight of 20kg.
Hire the portable bearing heater TIH030m
Hire rate for 1st day: £230
Each consecutive day thereafter: £100 per day
The TIH 030m is a compact and lightweight solution that is capable of heating bearings within a matter of minutes. Use this 230v induction bearing heater to fit bearings with a bore diameter from 20mm to 300mm and a maximum weight of 40Kg.
Hire the medium TIH100m bearing heater
Hire rate for 1st day: £340
Each consecutive day thereafter: £160 per day
Capable of heating a 97Kg bearing within an impressive 20 minutes, the TIH100m 230v induction heater can be used to fit bearings with a bore diameter from 20mm to 400mm & up to a maximum weight of 120kg. The heater is equipped with a heating time mode which can bew used to heat other components such as pulleys.
Hire this large TIH220m bearing heater
Hire rate for 1st day: £750
Each consecutive day thereafter: £275 per day
This low voltage induction heater is ideal for mounting bearings with bore diameters between 60mm & 600mm and up to a maximum component weight of 300kg. The TIH220m LV is a low voltage bearing heater which is capable of heating a 220Kg bearing in just 20 minutes.
MOBILE HEATING SERVICE
Hire a service engineer to heat and mount your workpiece for £995
ACORN also offer a full heating and mounting service to save you precious time, while ensuring bearings are mounted safely and securely, for a fraction of the cost of an induction heater.
An experienced SKF service engineer will visit your site to ensure bearings are heated and fitted correctly. This service can also be used for other components such as gears, couplings and spacers etc.
SKF TIH 220m
- Capable of heating a 220kg (480lb) bearing in just 20 minutes.
- Two yokes, allowing bearings with a bore diameter from 60mm (2.3in)up to a maximum weight of 300kg (660lb) to be heated.
- Sliding arm for large size yoke.
- 415v twin phase 32A supply required.