KM 18, RHP, Locknut
Nut, Steel, M 90x2, EAN code: 00747023116539
KM 16, RHP, Locknut
Nut, Steel, M 80x2, EAN code: 00747023116515
MB 10, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115754
MB 38, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023116270
MB 0, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023159161
MB 11, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115761
MB 13, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115815
MB 14, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115839
MB 15, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115846
MB 16, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115860
MB 17, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115884
MB 18, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115907
MB 2, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115587
MB 20, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115945
MB 21, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115976
MB 22, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023115983
MB 23, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023116003
MB 24, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023116027
MB 25, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023116058
MB 26, RHP, Locking washer
Tab Washer, Steel, EAN code: 00747023116072
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.