W 18, SKF, Locking washer
Washer, Steel, EAN code: 7316576676130
ZW 80X90, SKF, Spacing washer
Washer, Steel, EAN code: 7316571385631
HM 42 T, SKF, T lock/dismounting nut
Nut, Steel, Tr 210x4, EAN code: 7316577010612
KMT 34, SKF, Precision Lock nut
Nut, Steel, M 170x3, EAN code: 7316577655158
KMT 38, SKF, Precision Lock nut
Nut, Steel, M 190x3, EAN code: 7316577655172
KM 40, SKF, Locknut
Nut, Steel, M 200x3, EAN code: 7316577011350
MB 1, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316570872781
KMT 5, SKF, Precision Lock nut
Nut, Steel, M 25x1.5, EAN code: 7316577662743
KMF 6, SKF, Lock nut with integral locking screw
Nut, Steel, M 30x1.5
Z 307, SKF, Sealing washer, standard design
Washer, Steel, EAN code: 7316571351230
AN 16, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571353487
MB 48, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577001405
MB 56, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011794
MS 3056, SKF, Locking clip
Securing plate, Steel, EAN code: 7316577011831
MB 23, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011664
MB 27, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011695
KMT 22, SKF, Precision Lock nut
Nut, Steel, M 110x2, EAN code: 7316577655097
KMT 30, SKF, Precision Lock nut
Nut, Steel, M 150x2, EAN code: 7316577655134
KMT 7, SKF, Precision Lock nut
Nut, Steel, M 35x1.5, EAN code: 7316577292605
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.