KM 2 Nyloc, Neutral, Locknut
Nut, Steel, M 15x1
KM 5, Neutral, Locknut
Nut, Steel, M 25x1.5
KMT 12, SKF, Precision Lock nut
Nut, Steel, M 60x2, EAN code: 7316577294982
AN 30, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316576660504
MB 14, Neutral, Locking washer
Tab Washer, Steel
MB 18, Neutral, Locking washer
Tab Washer, Steel
MB 21, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011640
MB 24, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316571498904
KMT 14, SKF, Precision Lock nut
Nut, Steel, M 70x2, EAN code: 7316577656513
KMT 4, SKF, Precision Lock nut
Nut, Steel, M 20x1, EAN code: 7316577662736
KMT 5, SKF, Precision Lock nut
Nut, Steel, M 25x1.5, EAN code: 7316577662743
KM 11, Neutral, Locknut
Nut, Steel, M 55x2
KM 22 Nyloc, Neutral, Locknut
Nut, Steel, M 110x2
KM 3, SKF, Locknut
Nut, Steel, M 17x1, EAN code: 7316571249797
KM 30, SKF, Locknut
Nut, Steel, M 150x2, EAN code: 7316577011282
KM 9 Nyloc, Neutral, Locknut
Nut, Steel, M 45x1.5
Z 009, SKF, Sealing washer, standard design
Washer, Steel, EAN code: 7316570221565
Z 206 F, SKF, Sealing washers, F design
Washer, Steel
TW111, Timken, Locking washer
Washer, Steel, EAN code: 0053893821917
TW112, Timken, Locking washer
Washer, Steel, EAN code: 0053893822075
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.