KM 9, Timken, Locknut
Nut, Steel, M 45x1.5, EAN code: 0087796028845
KMK 13, SKF, Lock nut with integral locking screw
Nut, Steel, M 65x2, EAN code: 7316570928730
KMT 0, Neutral, Precision Lock nut
Nut, Steel, M 10x0.75
KMT 1, Neutral, Precision Lock nut
Nut, Steel, M 12x1
KMT 13, NKE, Precision Lock nut
Nut, Steel, M 65x2, EAN code: 9008745233494
KMT 14, Neutral, Precision Lock nut
Nut, Steel, M 70x2
KMT 32, Neutral, Precision Lock nut
Nut, Steel, M 160x3
Z 001, SKF, Sealing washer, standard design
Washer, Steel, EAN code: 7316571353548
Z 005 F, SKF, Sealing washers, F design
Washer, Steel, EAN code: 7316571146027
Z 014, SKF, Sealing washer, standard design
Washer, Steel, EAN code: 7316571353586
Z 208, SKF, Sealing washer, standard design
Washer, Steel
Z 213 F, SKF, Sealing washers, F design
Washer, Steel, EAN code: 7316570334371
Z 216, SKF, Sealing washer, standard design
Washer, Steel
Z 305, SKF, Sealing washer, standard design
Washer, Steel
Z 310, SKF, Sealing washer, standard design
Washer, Steel, EAN code: 7316571351278
ZM20, INA, Precision locknut
Precision locknut, Steel, M20X1, EAN code: 4012802079326
ZW 17X24, SKF, Spacing washer
Washer, Steel
ZW 35X42, SKF, Spacing washer
Washer, Steel, EAN code: 7316570964356
ZW 40X47, SKF, Spacing washer
Washer, Steel, EAN code: 7316571351070
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.