KM 12, RHP, Locknut
Nut, Steel, M 60x2, EAN code: 00747023116478
KM 13, RHP, Locknut
Nut, Steel, M 65x2, EAN code: 00747023116485
KM 14, RHP, Locknut
Nut, Steel, M 70x2, EAN code: 00747023116492
KM 15, RHP, Locknut
Nut, Steel, M 75x2, EAN code: 00747023116508
KM 17, RHP, Locknut
Nut, Steel, M 85x2, EAN code: 00747023116522
KM 19, RHP, Locknut
Nut, Steel, M 95x2, EAN code: 00747023116546
KM 2, RHP, Locknut
Nut, Steel, M 15x1, EAN code: 00747023116379
KM 20, RHP, Locknut
Nut, Steel, M 100x2, EAN code: 00747023116553
KM 21, RHP, Locknut
Nut, Steel, M 105x2, EAN code: 00747023116560
KM 22, RHP, Locknut
Nut, Steel, M 110x2, EAN code: 00747023116577
KM 23, RHP, Locknut
Nut, Steel, M 115x2, EAN code: 00747023116584
KM 24, RHP, Locknut
Nut, Steel, M 120x2, EAN code: 00747023116591
KM 25, RHP, Locknut
Nut, Steel, M 125x2, EAN code: 00747023116607
KM 26, RHP, Locknut
Nut, Steel, M 130x2, EAN code: 00747023116614
KM 27, RHP, Locknut
Nut, Steel, M 135x2, EAN code: 00747023116621
KM 28, RHP, Locknut
Nut, Steel, M 140x2, EAN code: 00747023116638
KM 29, RHP, Locknut
Nut, Steel, M 145x2, EAN code: 00747023116645
KM 3, RHP, Locknut
Nut, Steel, M 17x1, EAN code: 00747023116386
KM 30, RHP, Locknut
Nut, Steel, M 150x2, EAN code: 00747023116652
KM 31, RHP, Locknut
Nut, Steel, M 155x3, EAN code: 00747023116669
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.