KMT 38, SKF, Precision Lock nut
Nut, Steel, M 190x3, EAN code: 7316577655172
This item is not currently available from our stocks.
Despatch date information is on request.
KMK 3, SKF, Lock nut with integral locking screw
Nut, Steel, M 17x1, EAN code: 7316571483535
AN 20, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316576660443
KMT 7, SKF, Precision Lock nut
Nut, Steel, M 35x1.5, EAN code: 7316577292605
KM 14, Neutral, Locknut
Nut, Steel, M 70x2
KM 21, Neutral, Locknut
Nut, Steel, M 105x2
MB 21, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011640
TW065, Timken, Locking washer
Washer, Steel, EAN code: 0053893200989
KMT 10, SKF, Precision Lock nut
Nut, Steel, M 50x1.5, EAN code: 7316577314062
KMT 9, SKF, Precision Lock nut
Nut, Steel, M 45x1.5, EAN code: 7316577294951
KM 15 Nyloc, Neutral, Locknut
Nut, Steel, M 75x2
KM 5, Neutral, Locknut
Nut, Steel, M 25x1.5
MB 14, Neutral, Locking washer
Tab Washer, Steel
MB 20, Neutral, Locking washer
Tab Washer, Steel
MB 29, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011718
N 13, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385488
N 14, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385471
W 15, SKF, Locking washer
Washer, Steel, EAN code: 7316571385655
MB 32, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011732
TN11, Timken, Lock nut
Nut, Steel, EAN code: 0053893000923
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.