KM 2, SKF, Locknut
Nut, Steel, M 15x1, EAN code: 7316577754301
KM 28, SKF, Locknut
Nut, Steel, M 140x2, EAN code: 7316577011268
KMT 11, SKF, Precision Lock nut
Nut, Steel, M 55x2, EAN code: 7316577655028
KMT 5, SKF, Precision Lock nut
Nut, Steel, M 25x1.5, EAN code: 7316577662743
KMT 7, SKF, Precision Lock nut
Nut, Steel, M 35x1.5, EAN code: 7316577292605
KMTA 11, SKF, KMTA precision lock nut with locking pins
Nut, Steel, M 55x1.5, EAN code: 7316577655257
MB 4, Neutral, Locking washer
Tab Washer, Steel
W 20, SKF, Locking washer
Washer, Steel, EAN code: 7316576676154
KMTA 20, SKF, KMTA precision lock nut with locking pins
Nut, Steel, M 100x2, EAN code: 7316577655349
TAN21, Timken, Lock nut
Nut, Steel, EAN code: 0053893001470
This item is not currently available from our stocks.
Despatch date information is on request.
ZW 65X72, SKF, Spacing washer
Washer, Steel, EAN code: 7316571351094
KM 4, Neutral, Locknut
Nut, Steel, M 20x1
KM 9 Nyloc, Neutral, Locknut
Nut, Steel, M 45x1.5
KMFE 4, SKF, Lock nut with integral locking screw
Nut, Steel, M20x1, EAN code: 7316571584683
KMT 9, SKF, Precision Lock nut
Nut, Steel, M 45x1.5, EAN code: 7316577294951
W 13, SKF, Locking washer
Washer, Steel, EAN code: 7316571385587
KM 27, SKF, Locknut
Nut, Steel, M 135x2, EAN code: 7316577011251
KM 38, SKF, Locknut
Nut, Steel, M 190x3, EAN code: 7316577011343
KMK 9, SKF, Lock nut with integral locking screw
Nut, Steel, M 45x1.5, EAN code: 7316571106991
TAN130, Timken, Lock nut
Nut, Steel, EAN code: 0053893004136
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.