MB 3, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316570545975
MB 4, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316570803693
KM 18, SKF, Locknut
Nut, Steel, M 90x2, EAN code: 7316577011169
KMFE 7, SKF, Lock nut with integral locking screw
Nut, Steel, M35x1.5, EAN code: 7316571584799
MB 20, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011633
MB 24, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316571498904
KM 24, SKF, Locknut
Nut, Steel, M 120x2, EAN code: 7316577011220
KMT 4, SKF, Precision Lock nut
Nut, Steel, M 20x1, EAN code: 7316577662736
N 09, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385501
W 08, SKF, Locking washer
Washer, Steel, EAN code: 7316571385532
KM 12, Neutral, Locknut
Nut, Steel, M 60x2
KM 15, SKF, Locknut
Nut, Steel, M 75x2, EAN code: 7316571770253
KM 30, SKF, Locknut
Nut, Steel, M 150x2, EAN code: 7316577011282
KM 5, Neutral, Locknut
Nut, Steel, M 25x1.5
MB 15, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316571770260
W 10, SKF, Locking washer
Washer, Steel, EAN code: 7316571385556
W 12, SKF, Locking washer
Washer, Steel, EAN code: 7316571385570
KM 20, SKF, Locknut
Nut, Steel, M 100x2, EAN code: 7316577011183
KM 7 Nyloc, Neutral, Locknut
Nut, Steel, M 35x1.5
MB 12, Neutral, Locking washer
Tab Washer, Steel
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.