AN 16, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571353487
MB 11, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316570627305
KM 13, Neutral, Locknut
Nut, Steel, M 65x2
KM 32, SKF, Locknut
Nut, Steel, M 160x3, EAN code: 7316577011305
KM 7, Neutral, Locknut
Nut, Steel, M 35x1.5
W 06, SKF, Locking washer
Washer, Steel, EAN code: 7316571396620
KM 2, SKF, Locknut
Nut, Steel, M 15x1, EAN code: 7316577754301
KMFE 11, SKF, Lock nut with integral locking screw
Nut, Steel, M55x2, EAN code: 7316571585192
KMK 6, SKF, Lock nut with integral locking screw
Nut, Steel, M 30x1.5, EAN code: 7316577711137
KMT 24, SKF, Precision Lock nut
Nut, Steel, M 120x2, EAN code: 7316577655103
TW103, Timken, Locking washer
Washer, Steel, EAN code: 0053893822013
This item is not currently available from our stocks.
Despatch date information is on request.
MB 22, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011657
MB 26, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011688
MB 28, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011701
MB 3, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316570545975
KMT 11, SKF, Precision Lock nut
Nut, Steel, M 55x2, EAN code: 7316577655028
KMT 6, SKF, Precision Lock nut
Nut, Steel, M 30x1.5, EAN code: 7316577291851
KM 14 Nyloc, Neutral, Locknut
Nut, Steel, M 70x2
KM 28, SKF, Locknut
Nut, Steel, M 140x2, EAN code: 7316577011268
KMFE 7, SKF, Lock nut with integral locking screw
Nut, Steel, M35x1.5, EAN code: 7316571584799
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.