KM 8, SKF, Locknut
Nut, Steel, M 40x1.5
MB 8, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316570517996
W 17, SKF, Locking washer
Washer, Steel, EAN code: 7316571385617
This item is not currently available from our stocks.
Despatch date information is on request.
MB 17, Neutral, Locking washer
Tab Washer, Steel
KM 7, SKF, Locknut
Nut, Steel, M 35x1.5, EAN code: 7316571353456
KM 12, SKF, Locknut
Nut, Steel, M 60x2
KM 11, SKF, Locknut
Nut, Steel, M 55x2, EAN code: 7316577758897
KM 4, SKF, Locknut
Nut, Steel, M 20x1
KM 10, SKF, Locknut
Nut, Steel, M 50x1.5, EAN code: 7316571353463
KM 6, SKF, Locknut
Nut, Steel, M 30x1.5, EAN code: 7316577757432
KM 9, SKF, Locknut
Nut, Steel, M 45x1.5, EAN code: 7316577758323
KM 14, SKF, Locknut
Nut, Steel, M 70x2, EAN code: 7316571770277
KM 5, SKF, Locknut
Nut, Steel, M 25x1.5, EAN code: 7316577758880
MB 5, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316571066462
KM 17, SKF, Locknut
Nut, Steel, M 85x2, EAN code: 7316571770208
MB 44, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011787
KM 18, SKF, Locknut
Nut, Steel, M 90x2, EAN code: 7316577011169
ZW 85X100, SKF, Spacing washer
Washer, Steel
N 09, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385501
MB 6, SKF, Locking washer
Tab Washer, Steel
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.