KM 19, SKF, Locknut
Nut, Steel, M 95x2, EAN code: 7316577011176
MB 11, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316570627305
MB 12, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577758538
MB 9, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577758316
N 10, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385495
MB 18, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011619
MB 7, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577757456
KM 3, SKF, Locknut
Nut, Steel, M 17x1, EAN code: 7316571249797
MB 22, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011657
KM 18, SKF, Locknut
Nut, Steel, M 90x2, EAN code: 7316577011169
MB 28, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011701
KMT 6, SKF, Precision Lock nut
Nut, Steel, M 30x1.5, EAN code: 7316577291851
KM 16, SKF, Locknut
Nut, Steel, M 80x2, EAN code: 7316571770239
KM 26, SKF, Locknut
Nut, Steel, M 130x2, EAN code: 7316577011244
AN 16, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571353487
KM 8 Nyloc, Neutral, Locknut
Nut, Steel, M 40x1.5
KMT 8, SKF, Precision Lock nut
Nut, Steel, M 40x1.5, EAN code: 7316577655011
KM 17, SKF, Locknut
Nut, Steel, M 85x2, EAN code: 7316571770208
KM 22, SKF, Locknut
Nut, Steel, M 110x2, EAN code: 7316577011206
W 07, SKF, Locking washer
Washer, Steel, EAN code: 7316571385525
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.