ZW 65X72, SKF, Spacing washer
Washer, Steel, EAN code: 7316571351094
KM 15, Neutral, Locknut
Nut, Steel, M 75x2
KM 21, SKF, Locknut
Nut, Steel, M 105x2, EAN code: 7316577011190
KM 4, Neutral, Locknut
Nut, Steel, M 20x1
KMFE 6, SKF, Lock nut with integral locking screw
Nut, Steel, M30x1.5, EAN code: 7316571584782
KMT 20, SKF, Precision Lock nut
Nut, Steel, M 100x2, EAN code: 7316577655080
KMT 9, SKF, Precision Lock nut
Nut, Steel, M 45x1.5, EAN code: 7316577294951
MB 13, Neutral, Locking washer
Tab Washer, Steel
MB 2, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577757968
W 06, SKF, Locking washer
Washer, Steel, EAN code: 7316571396620
W 13, SKF, Locking washer
Washer, Steel, EAN code: 7316571385587
KM 38, SKF, Locknut
Nut, Steel, M 190x3, EAN code: 7316577011343
KMTA 20, SKF, KMTA precision lock nut with locking pins
Nut, Steel, M 100x2, EAN code: 7316577655349
This item is not currently available from our stocks.
Despatch date information is on request.
AN 28, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316576660498
KM 14, Neutral, Locknut
Nut, Steel, M 70x2
KM 23, SKF, Locknut
Nut, Steel, M 115x2, EAN code: 7316577011213
N 05, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571278735
N 10, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385495
MB 14, Neutral, Locking washer
Tab Washer, Steel
MB 17, Neutral, Locking washer
Tab Washer, Steel
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.