KMFE 8, SKF, Lock nut with integral locking screw
Nut, Steel, M40x1.5, EAN code: 7316571585093
MB 16, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316571770222
MB 21, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011640
KMK 19, SKF, Lock nut with integral locking screw
Nut, Steel, M 95x2, EAN code: 7316571179285
This item is not currently available from our stocks.
Despatch date information is on request.
KMK 4, SKF, Lock nut with integral locking screw
Nut, Steel, M 20x1, EAN code: 7316571483542
KMT 9, SKF, Precision Lock nut
Nut, Steel, M 45x1.5, EAN code: 7316577294951
W 16, SKF, Locking washer
Washer, Steel, EAN code: 7316571385600
KM 30, SKF, Locknut
Nut, Steel, M 150x2, EAN code: 7316577011282
AN 15, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571353623
KM 16 Nyloc, Neutral, Locknut
Nut, Steel, M 80x2
KM 21, SKF, Locknut
Nut, Steel, M 105x2, EAN code: 7316577011190
KM 32, SKF, Locknut
Nut, Steel, M 160x3, EAN code: 7316577011305
KM 6, Neutral, Locknut
Nut, Steel, M 30x1.5
KM 7, Neutral, Locknut
Nut, Steel, M 35x1.5
KMFE 14, SKF, Lock nut with integral locking screw
Nut, Steel, M70x2, EAN code: 7316571585345
KML 30, SKF, Locknut
Nut, Steel, M 150x2, EAN code: 7316577055668
MB 11, Neutral, Locking washer
Tab Washer, Steel
MB 15, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316571770260
W 28, SKF, Locking washer
Washer, Steel, EAN code: 7316576676208
KMTA 11, SKF, KMTA precision lock nut with locking pins
Nut, Steel, M 55x1.5, EAN code: 7316577655257
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.