MB 20, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011633
AN 26, SKF, AN inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316576660481
N 11, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385686
MB 30, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011725
KM 6 Nyloc, Neutral, Locknut
Nut, Steel, M 30x1.5
KMF 1, SKF, Lock nut with integral locking screw
Nut, Steel, M 12x1, EAN code: 7316580969044
KMT 11, SKF, Precision Lock nut
Nut, Steel, M 55x2, EAN code: 7316577655028
KM 26, SKF, Locknut
Nut, Steel, M 130x2, EAN code: 7316577011244
KM 32, SKF, Locknut
Nut, Steel, M 160x3, EAN code: 7316577011305
ZW 75X85, SKF, Spacing washer
Washer, Steel, EAN code: 7316571351117
TW111, Timken, Locking washer
Washer, Steel, EAN code: 0053893821917
N 14, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571385471
KMFE 8, SKF, Lock nut with integral locking screw
Nut, Steel, M40x1.5, EAN code: 7316571585093
KM 1, Timken, Locknut
Nut, Steel, M 12x1, EAN code: 0087796212732
MB 15, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316571770260
MB 27, SKF, Locking washer
Tab Washer, Steel, EAN code: 7316577011695
KM 27, SKF, Locknut
Nut, Steel, M 135x2, EAN code: 7316577011251
KM 40, SKF, Locknut
Nut, Steel, M 200x3, EAN code: 7316577011350
N 05, SKF, N inch lock nut, requiring a keyway
Nut, Steel, EAN code: 7316571278735
KMFE 7, SKF, Lock nut with integral locking screw
Nut, Steel, M35x1.5, EAN code: 7316571584799
Locknut and washer applications
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.