TAN136, Timken, Lock nut
Nut, Steel, EAN code: 0053893004280
TAN138, Timken, Lock nut
Nut, Steel, EAN code: 0053893004433
TAN140, Timken, Lock nut
Nut, Steel, EAN code: 0053893004563
TAN17, Timken, Lock nut
Nut, Steel, EAN code: 0053893001319
TAN20, Timken, Lock nut
Nut, Steel, EAN code: 0053893001395
TAN21, Timken, Lock nut
Nut, Steel, EAN code: 0053893001470
TW101, Timken, Locking washer
Washer, Steel, EAN code: 0053893821993
TW102, Timken, Locking washer
Washer, Steel, EAN code: 0053893822006
TW103, Timken, Locking washer
Washer, Steel, EAN code: 0053893822013
TW104, Timken, Locking washer
Washer, Steel, EAN code: 0053893822020
TW108, Timken, Locking washer
Washer, Steel, EAN code: 0053893822051
TW109, Timken, Locking washer
Washer, Steel, EAN code: 0053893822068
TW114, Timken, Locking washer
Washer, Steel, EAN code: 0053893822099
TW116, Timken, Locking washer
Washer, Steel, EAN code: 0053893816753
TW117, Timken, Locking washer
Washer, Steel, EAN code: 0053893821337
TW118, Timken, Locking washer
Washer, Steel, EAN code: 0053893822105
TW120, Timken, Locking washer
Washer, Steel, EAN code: 0053893822129
TW121, Timken, Locking washer
Washer, Steel, EAN code: 0053893817675
TW132, Timken, Locking washer
Washer, Steel, EAN code: 0053893822174
TW136, Timken, Locking washer
Washer, Steel, EAN code: 0053893811970
What types of locknuts and washers are available from Timken?
Lock Nuts are used to locate bearings and other components on shafts, as well as, to facilitate mounting and dismounting of bearings on withdrawal sleeves or tapered journals. Lock Nuts have equally spaced slots around the outside diameter to facilitate the use of a hook spanner or impact spanner.
Locking Washers are used to engage a groove in the shaft and secure the Lock Nut in position. When a washer with increased strength is needed, the MB. A design locking washer is the ideal choice.
Locking Clips are attached to the Shaft Nut using a screw with a hexagonal head.
Locking Plates are attached in the same way as the Locking Clips and are also supplied with a steel wire to pass through the holes in the head of each screw. The ends of the wire should be twisted together to prevent loosening of the screws.